Med vores cookies ønsker vi at tilbyde dig den bedst mulige shoppingoplevelse med alt, hvad der hører til. Dette inkluderer for eksempel passende tilbud, personlige annoncer og gemte præferencer. Hvis du er okay med dette, skal du blot acceptere brugen af cookies til præferencer, statistik og markedsføring ved at klikke på "I orden!" (vis alle). Du kan til enhver tid trække dit samtykke tilbage via cookie-indstillingerne (her)
Du skal være logget på, for at kunne vurdere et produkt.
BemærkVi tillader kun vores kunder, at afgive en vurdering af det udstyr de har købt hos os. Vi modtager ikke anmeldelser eller vurderinger af produkter fra tredje kilde.
Efter login finder du også i kundencenter under "vurderinger af produkt" alle artikler, som du kan afgive en vurdering af.
Ja, hvad kan man sige? Enheden leverer strøm til hele mit setup. For at jorde bør man lige huske at købe en adapter fra Schuko-jord til Dansk jord til væggen.
It would have been nearly perfect if only it wasn't slightly higher than the standard 2U height.
For that reason it didn't fit into my rack where only exactly 2U was available. Had to sell it.
The unit itself is well made and built really tough. The wire gauge used inside was more than sufficient, internal connections where made properly (screw terminals on the sockets + ring terminals on the wires if I remember correctly).
There was enough room inside to add few relays or some electronics and it was easy enough to rewire for my needs.
The unit is well-built and works well. The main issue is that the faceplate is slightly larger than the 2U standard: it's both too high and too wide by a couple of millimeters making it difficult to fit into a rack built to the standard. The result is that it overlaps units above and/or below it, and can run into issues fitting it between the rack' slides if they are flush against the rails. In my SKB rack I was forced to mount it with washers between the faceplate and the rails in order to lift it clear of the rack's edge and make sure it was in front of the other units in the rack in order to get it to fit. It works but should not have been required since there is a standard size for faceplates.
Used this Power Supply in various live and studio situations. Worked as promised - useful to connect multiple devices to a single grounded source, for example.