the t.amp Quadro 500 DSP

Start 360°

Vis oversættelse

30 dages-Money Back garanti

3 års Thomann garanti

Fås siden September 2018

Artikelnummer 438086

salgsenhed 1 stk

Power (4 Ohms) per Channel 500 W

Channels 4

Rack Units 1 U

Amp Class Class D

2 Ohm stable No

DSP/Crossover Yes

Convection cooling No

Width in mm 483 mm

Depth in mm 460 mm

Height in mm 44 mm

Weight 8 kg

Bridged Mode 1

Temperature controlled fan 1

Input XLR 1

Jack Input 6,3 sym. 1

Link Out No

Output Speaker Twist 1

Vis mere

4.399 kr

Alle priser inkl. moms

Salgsrang

i Forstærkere

Pakker & tilbud

the box pro Achat Quadro Acoustic Set

11.777 kr

the box pro Achat 108CX/112Sub Quadro Set

12.990 kr

the box pro Achat 110/112 Quadro Set

13.666 kr

the box pro Achat 404/112 Quadro Gala Set

15.555 kr

the box pro Achat 804/112 Quadro Gala Set

16.690 kr

Kunder som så på dette produkt købte dette

the t.racks DSP 4x4 Amp 4.250

3.298 kr

86 Kundebedømmelser

5 58 Kunder 4 21 Kunder 3 4 Kunder 2 1 Kunde 1 2 Kunder

4.5 / 5

betjening

features

lyd

forarbejdning

Retningslinjer for anmeldelser

66 Anmeldelser

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Wasn't sure, but...!!

Adeler 20.05.2019

I ordered this amplifier because i have a 2 way system at home.
I was very unsure, but it turned out that the amplifier was very good.

Sound quality is great! Nothing to say about it! It's class D. No coloring of the sound as far as i am concerned

What i was unsure about was the ratings, it dosesn't say much about load/ohm/watt at what THD.
I have measured it to deliver 4x640w @ 4 ohms @ 1% THD so i am quite happy!

Also, i was exited to find out about noise from the fans. I can't hear them, really. There are two temperature controlled 80mm fans placed at an angle inside, pulling air from front and side and pushes it out on right side.

It's easy to use! Both the software and the on board controller works really great to set up, load, save and adjust presets and settings.

I REALLY recommends this amplifier, especialy for home use (Example; home teatre/home cinema, multi way setups and sub arrays)

I don't know if there are any amplifiers that can compare with this one for the price, and maybe even even more expensive amplifiers.

betjening

features

lyd

forarbejdning

Anmeld bedømmelse

Synes du at denne vurdering er forkert eller af en anden grund ikke læselig? Vær venlig at skrive i det følgende kommentarfelt hvorfor og hvis muligt din email-adresse, så vi kan give dig en tilbage melding til din kommentar.

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Perfect amp for creating an 8-way monitor mix!

heyimdan-dan 09.06.2021

I bought two Quadro 500 DSP power amps to ditch four very heavy amplifiers that were taking up 8U of rack space. I was unsure about how well these amps would perform, but after getting them hooked up to my wedges (250w 8ohm speakers) there was little doubt that I'd retain all the power I had before and make a lighter rack case.

The main attraction meant I could have a single rack that connected the two amps directly to my Midas DL32 stage box, with all the speaker DSP in there too, making for a very compact and quick gig set up.

The interface is great and very straight forward with lots of features I'll likely never need, but it's great to know it's there. From within the menu you can pair up XLR inputs to XLR channels. For example, Input A will send the source to Output A and B. Sadly you can't currently send Input A to say Outputs ABC&D. That would be very handy for particular circumstances, especially since there aren't any XLR thru's to link channels. But some XLR splitter leads can navigate that issue. (EDIT: I have since worked out how to take the input from channel A and use it to drive all four speaker outputs)

Considering buying more to run my FOH high frequency drivers. (EDIT: I bought two more of these amps to run the HF drivers in my 16 box line array, with 8 boxes per side. Each HF driver is 16 ohms, and there are two in each cabinet. I use one speaker output channel to run 4 HF drivers, and with the volume level at -12db, so the amp is only outputting at about 60-70 watts and this is more than enough. The clarity is excellent and I can’t fault it.)

betjening

features

lyd

forarbejdning

Anmeld bedømmelse

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

best choice for this price

Oliver Kocsis 30.01.2019

I use it in a church, to everyone's satisfaction, it was the best choice, I chose because of theintegrated DSP and delay, together with a Behringer xr16 (fixed install, no buttons, no faders= no problem with amateur sound guys). Crystal clear sound, good damping factor, simply and useful one button menu for configuration, all for a very good price. I am also pleased with the customer.

betjening

features

lyd

forarbejdning

Anmeld bedømmelse

Vis oversættelse

Vis original

Der opstod en fejl. Prøv igen senere.

Quality Equipment

Raymmy J 06.04.2025

Great amplifier for ALL my needs!

betjening

features

lyd

forarbejdning

Anmeld bedømmelse

Læs alle anmeldelser

the t.amp Quadro 500 DSP

4-Channel Digital Power Amplifier

4-kanals digital effektforstærker

Kunder som så på dette produkt købte dette

86 Kundebedømmelser

Du skal være logget på, for at kunne vurdere et produkt.

66 Anmeldelser

Smart Navigator

Serveret med kærlighed!

the t.amp Quadro 500 DSP

4-Channel Digital Power Amplifier

4-kanals digital effektforstærker

Kunder som så på dette produkt købte dette

Tilbehør og matchende produkter

86 Kundebedømmelser

Du skal være logget på, for at kunne vurdere et produkt.

66 Anmeldelser

Sammenlign valgmuligheder

Smart Navigator