Med vores cookies ønsker vi at tilbyde dig den bedst mulige shoppingoplevelse med alt, hvad der hører til. Dette inkluderer for eksempel passende tilbud, personlige annoncer og gemte præferencer. Hvis du er okay med dette, skal du blot acceptere brugen af cookies til præferencer, statistik og markedsføring ved at klikke på "I orden!" (vis alle). Du kan til enhver tid trække dit samtykke tilbage via cookie-indstillingerne (her)
Du skal være logget på, for at kunne vurdere et produkt.
BemærkVi tillader kun vores kunder, at afgive en vurdering af det udstyr de har købt hos os. Vi modtager ikke anmeldelser eller vurderinger af produkter fra tredje kilde.
Efter login finder du også i kundencenter under "vurderinger af produkt" alle artikler, som du kan afgive en vurdering af.
Solidt valg til formålet.
Men der måtte godt medfølge et lille diagram over konstruktionen og placering af ledningerne til dem, der ikke er hjemmevandte med montering
I used these for my pedalboard. I made my own pedalboard out of wood. And This has an storage are bottom where I put all the wires. These sockets were added to the sides, for input and output. I am very pleased!
I ordered this jack to repleace the original one of my Aria bass for it was too loose to hold the plug. The jack is stereo. I soldered a short wire to connect ring and sleeve. The contacs readily accept lead and are easy to solder. The surface of the jack is milled and easy to grip with pliers. That way you can work up enough torque to safely tighten the locknut. That and the rubber washer provide a tight fit.
The jack grabs an 1/4" phone and holds it very firm. It takes a little force to actually unplug the connection but that is excactly what i was looking for.
Would buy again.