Med vores cookies ønsker vi at tilbyde dig den bedst mulige shoppingoplevelse med alt, hvad der hører til. Dette inkluderer for eksempel passende tilbud, personlige annoncer og gemte præferencer. Hvis du er okay med dette, skal du blot acceptere brugen af cookies til præferencer, statistik og markedsføring ved at klikke på "I orden!" (vis alle). Du kan til enhver tid trække dit samtykke tilbage via cookie-indstillingerne (her)
Du skal være logget på, for at kunne vurdere et produkt.
BemærkVi tillader kun vores kunder, at afgive en vurdering af det udstyr de har købt hos os. Vi modtager ikke anmeldelser eller vurderinger af produkter fra tredje kilde.
Efter login finder du også i kundencenter under "vurderinger af produkt" alle artikler, som du kan afgive en vurdering af.
Really neat way to split TRRS signals to get them in an out of professional gear
Frank Flanagan 17.09.2021
I am currently using two of these to split TRRS signals into and out of DI channels to connect them to professional gear while killing ground loop noise.
I have made up one TRRS to XLR cable for each channel, picking up the appropriate signal in the TRRS.
This is more flexible and neater than splitting everything on a hardwired patch panel or putting a box onto the cable with one TRRS and 3 XLR connectors.
Note: on most TRRS connections you need will to put about a 10K shunt resistor between mic and ground (to convince the PC/iPhone etc that there is a mic present) and run the signal through perhaps a 1uF ceramic cap (to block the bias voltage provided to power headset mics).
Ich hab den Splitter nicht geöffnet, aber er ist sehr leicht, wodurch er in der Hand nicht so solide wirkt wie andere. Die Funktion scheint aber gegeben und in manchen Fällen ist das geringe Gewicht vermutlich ein Vorteil.
Die Kabel rasten kräftig ein und halten gut.
Kein Klagen bisher :-)